UltraSonic Hardness Tester

Fowler's new Ultrasonic Hardness Tester works on a principle of vibration to measure hardness electrically and through a sophisticated algorithm, converts the measured signal into a accurate, repetitive measurement.

UltraSonic Tester Features

Compact size for portable use. Direct-reading of hardness by digital display. Very small indentation < 0.001" Conversion between HV and HRC. Works with or without standard base. Multi direction applicability, works in any direction.

Specifications

Indenter Diamond	90 o Indenter for micro-Vickers/conversion to Rockwell C
Test load	Approximately 2 Kgf (4.41 lb.f) constant load spring
Measuring ranges	Measuring ranges Standard type." HV/HRC
Measuring accuracy	HV ±3% of reading. HRC±1.0
Applicable test	Primarily steel, other materials using a calibration block.
Measuring displayed	Digital (4 figures LED)
Resolution	1 HV / 0.1 HRC
Operating temperature	0-50C (instruments)
Power source	AC110/220V(+10%) and NiCad battery (rechargeable)
Display unit size	8 " W x 3" Dx 4" H 200 (W) x 68(D) x100 (H).)
Display unit weight	1.54 lbs. (0.7Kg)
Probe weight	.77 lbs. (0.35Kg)